This 6-1/2in x 12-1/2in rectangle ruler features easy-to-read black and white markings printed in 1in grids marked in 1/8in and 1/4in increments.
Use the easy-to-read, black numbers (printed on white dots) and the 1/4in grip sides to cut whole inches. The 1/4in dashed lines printed on two adjoining sides aid in trimming seam allowances.
Use the patented Turn-A-Round feature – designated by the easy to read, numerical white numbers (printed on black dots) and the 1/2in grip sides – to add the 1/2in seam allowance.
The ruler slides easily over the fabric until pressure is applied. Then, our exclusive gripper holds the fabric in place while cutting, eliminating slipping and mis-cuts!
Use the white 45 degree angle to trim half-square triangles in whole inch increments. Use the black 45 degree angle to trim half-square triangles in half inch increments. An additional black 45 degree line is placed so that two angles cross 1/4in away from the outside edge. Use these markings to square up flying geese units; squares set on point or mark cross-hatching. The ruler also features a 30degree/60degree angle.
White horizontal and vertical lines are printed on the rectangle so the center of the ruler is easily distinguishable. Use these lines to fussy cut stripes and borders.